Panasonic WVNP472 WVNP472 User Guide - Page 27
Set the IP address of DNS when using the DNS server.
View all Panasonic WVNP472 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 27 highlights
Connection type 2 Connection type 3 IP address Subnet mask Default gateway Network speed HTTP port Host name DNS Primary server Secondary server DHCP IP address Subnet mask Default gateway Network speed HTTP port Host name DNS Primary server Set the IP address designated by your network administrator. However, the setting is not required if DHCP is used in an intranet. Set the subnet mask designated by your network administrator. However, the setting is not required if DHCP is used in an intranet. Set the IP address of the default gateway designated by your network administrator. However, the setting is not required if DHCP is used in an intranet. Set the network speed. Use the default setting "auto" for the network speed. Selectable parameters: auto (default setting), 100 Mbps (full duplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10 Mbps (half duplex) Use the default setting "80" for the HTTP port. Refer to your network administrator and set the designated host name if required. Set to ON when using the DNS server. No setting required Set the IP address of DNS when using the DNS server. Refer to your Internet service provider for the IP address of DNS. Primary and secondary IP addresses can be set for the DNS. Set to ON if the intranet uses DHCP. Set the IP address designated by your Internet service provider. However, the setting is not required if your Internet service provider uses a DHCP server (the DHCP server assigns an IP address to the camera automatically). Set the subnet mask designated by your Internet service provider. However, the setting is not required if your Internet service provider uses a DHCP server (the DHCP server assigns an IP address to the camera automatically). Set the default gateway designated by your Internet service provider. Set the network speed. Use the default setting "auto" for the network speed. Selectable parameters: auto (default setting), 100 Mbps (full duplex), 100 Mbps (half duplex), 10 Mbps (full duplex), 10 Mbps (half duplex) Use the default setting "80" for the HTTP port. Refer to your Internet service provider and set the designated host name if required. Set to ON when using the DNS server. No setting required -27-