Sony GDM-5510 Operation Guide - Page 3
Precautions
View all Sony GDM-5510 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 3 highlights
Precautions Warning on power connections Use an appropriate power cord for your local power supply. 115 Volts 230 Volts (not provided on standard cord set) CEE-22 cord set, female end (all power cord sets) United States, Continental Canada, Europe Taiwan, Korea, Japan United Kingdom, Ireland Australia, New Zealand Plug Type Plug Type NEMA S-15P CEE7/VII (Schuko) Plug Type B S 1363 Plug Type SAA AS 3112 Cord Type SJT Cord Type Cord Type Cord Type HAR(HO5VV HAR(HO5VV CDB03PLP -F3G1.0) -F3G1.0) Min. cord set rating 10 A/125 V 18/3AWG Min. cord set rating 10 A/250 V Min. cord set rating 10 A/250 V Min. cord set rating 10 A/250 V Cord Length Cord Length Cord Length Cord Length (+/- 0.1 m) (+/- 0.1 m) (+/- 0.1 m) (+/- 0.1 m) 2 m 2.5 m 2.5 m 2.5 m Safety Approval UL/CSA Safety Approval HAR Safety Approval BSI, ASTA Safety Approval Dept. of Energy of New South Wales Autoranging universal power supply works anywhere; the monitor self-adjusts if the appropriate power cord and plug for the local voltage are used. • Before disconnecting the power cord, wait at least 30 seconds after turning off the power to allow the static electricity on the screen's surface to discharge. • After the power is turned on, the screen is demagnetized (degaussed) for a few seconds. This generates a strong magnetic field around the screen which may affect data stored on magnetic tapes and disks placed near the monitor. Be sure to keep magnetic recording equipment, tapes, and disks away from the monitor. The equipment should be installed near an easily accessible outlet. Installation Do not install the monitor in the following places: • on surfaces (rugs, blankets, etc.) or near materials (curtains, draperies, etc.) that may block the ventilation holes • near heat sources such as radiators or air ducts, or in a place subject to direct sunlight • in a place subject to severe temperature changes • in a place subject to mechanical vibration or shock • on an unstable surface • near equipment which generates magnetism, such as a transformer or high voltage power lines • near or on an electrically charged metal surface Maintenance • Clean the screen with a soft cloth. If you use a glass cleaning liquid, do not use any type of cleaner containing an anti-static solution or similar additive as this may scratch the screen's coating. • Do not rub, touch, or tap the surface of the screen with sharp or abrasive items such as a ballpoint pen or screwdriver. This type of contact may result in a scratched picture tube. • Clean the cabinet, panel and controls with a soft cloth lightly moistened with a mild detergent solution. Do not use any type of abrasive pad, scouring powder or solvent, such as alcohol or benzene. Transportation EN When you transport this monitor for repair or shipment, use the original carton and packing materials. Use of the tilt-swivel This monitor can be adjusted within the angles shown below. To find the center of the monitor's turning radius, align the center of the monitor's screen with the centering dot on the stand. Hold the monitor at the bottom with both hands when you turn it horizontally or vertically. Be careful not to pinch your fingers at the back of the monitor when you tilt the monitor up vertically. 90° 14° 90° 5° 3