Sony RDR-HX900 Operating Instructions - Page 100
Others, OPEN/CLOSE. - service mode
UPC - 027242644328
View all Sony RDR-HX900 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 100 highlights
, Set the TV/DVD switch to DVD (page 22). Other Sony equipment responds to the remote. , The same command mode is set for both the equipment and recorder. Set a different command mode for the recorder (page 23). Others The recorder does not operate properly. , Restart the recorder. Press down "/1 on the recorder for more than ten seconds until "WELCOME" appears in the front panel display. , When static electricity, etc., causes the recorder to operate abnormally, turn off the recorder and wait until the clock appears in the front panel display. Then, unplug the recorder and after leaving it off for a while, plug it in again. Dubbing or DV/Digital8 Dubbing does not start. , A timer recording is in progress. Five numbers or letters are displayed on the front panel display. , The self-diagnosis function was activated (see the table on page 101). The disc tray does not open after you press Z OPEN/CLOSE. , It may take a few seconds for the disc tray to open after you have recorded or edited a DVD. This is because the recorder is adding disc data to the disc. The disc tray does not open and "TRAY LOCKED" appears on the front panel display. , Contact your Sony dealer or local authorized Sony service facility. "RECOVERY" appears in the front panel display. , The recorder's recovery function was activated when the recorder was turned on because the power was turned off or failed during recording. Leave the recorder on until "RECOVERY" disappears from the front panel display. "HDD ERROR" appears in the front panel display. , The hard disk error occurred. Press down @/1 on the recorder for ten seconds to restart the recorder. If this does not resolve the problem, format the recorder's HDD by pressing down the HDD button on the recorder for more than ten seconds until "WELCOME" appears in the front panel display. Note that all the contents recorded on the HDD will be erased. "FAN ERROR" appears in the front panel display. , Check that the vent on the rear of the recorder is not blocked. Then, turn off the recorder, wait until the clock appears in the front panel display, and disconnect the AC power cord. Leave the recorder off for a while, then re-connect the power cord, and press "/1 on the recorder. Mechanical sound is heard when the recorder is off. , While the recorder is adjusting the clock or downloading the TV Guide On Screen data, operational noises (such as the internal fan) may be heard, even when the power is off. This is not a malfunction. The disc tray does not open and you cannot remove the disc after you press Z OPEN/ CLOSE. , Turn off the recorder, Once the clock appears in the front panel display, disconnect the AC power cord. Connect it again while pressing down A on the recorder, and release the button when the disc tray opens. Then, keep [/1 on the recorder pressed for about ten seconds until "WELCOME" appears in the front panel display. "LOCKED" appears in the front panel display. , The disc tray is locked. Cancel the Child Lock (page 55). 100