Sony STR-DN1030 Operating Instructions (Large File - 11.51 MB) - Page 112

Resetting the remote control AV ?/1 RM ?/1 SET UP MASTER VOL -/ 2 - 1 While holding down MASTER VOL - or 2 -, press and hold ?/1, then press AV ?/1. The RM SET UP button flashes 3 times. 2 Release all buttons. All the contents of the remote control memory (i.e., all the programmed data) are cleared. Additional Information Precautions On safety Should any solid object or liquid fall into the cabinet, unplug the receiver and have it checked by qualified personnel before operating it any further. On power sources • Before operating the receiver, check that the operating voltage is identical with your local power supply. The operating voltage is indicated on the nameplate on the back of the receiver. • The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. • If you are not going to use the receiver for a long time, be sure to disconnect the receiver from the wall outlet. To disconnect the AC power cord (mains lead), grasp the plug itself; never pull the cord. • (USA and Canada models only) One blade of the plug is wider than the other for the purpose of safety and will fit into the wall outlet only one way. If you are unable to insert the plug fully into the outlet, contact your dealer. • The AC power cord (mains lead) must be changed only at a qualified service shop. On heat buildup Although the receiver heats up during operation, this is not a malfunction. If you continuously use this receiver at a large volume, the cabinet temperature of the top, side and bottom rises considerably. To avoid burning yourself, do not touch the cabinet. 112US