Sony STR-DN1030 Operating Instructions (Large File - 11.51 MB) - Page 44
Configuring the network settings of the receiver, Using a wireless LAN connection - problems
View all Sony STR-DN1030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 44 highlights
Message list after Auto Calibration measurement Display and explanation Error Code 31 The SPEAKERS is set to off. Set to other speaker settings and perform the Auto Calibration again. Error Code 32 Error Code 33 Speakers were not detected or not connected properly. • None of the front speakers are connected or only one front speaker is connected. • Either the surround left or surround right speaker is not connected. • Surround back speakers or front high speakers are connected even though surround speakers are not connected. Connect the surround speaker(s) to the SPEAKERS SURROUND terminals. • The surround back speaker is connected only to the SPEAKERS SURROUND BACK/FRONT HIGH/BI-AMP/FRONT B R terminals. When you connect only one surround back speaker, connect it to the SPEAKERS SURROUND BACK/FRONT HIGH/BI-AMP/FRONT B L terminals. • Either the front left high or front right high speaker is not connected. The optimizer microphone is not connected. Make sure that the optimizer microphone is connected properly and perform the Auto Calibration again. If the optimizer microphone is connected properly but the error code still appears, the optimizer microphone cable may be damaged. Warning 40 The measurement process has completed with high noise level detection. You may be able to achieve better results if you try in a quiet environment again. Warning 41 Warning 42 The input from the microphone is too big. • The distance between the speaker and the microphone may be too close. Set them apart and perform the measurement again. Warning 43 The distance and position of a subwoofer cannot be detected. This may be caused by noise. Try to perform the measurement in a quiet environment. No Warning There is no warning information. Tip Depending on the position of the subwoofer, the measurement results may vary. However, there will be no problems even if you continue to use the receiver with that value. 44US Configuring the network settings of the receiver The network settings for the receiver must be set correctly to use the Home Network, SEN, AirPlay, and PARTY STREAMING functions. Using a wireless LAN connection There are several connecting methods you can use to set up a wireless network: searching for an access point, using a WPS connecting method (either the push-button method or the PIN code method), or manual setting. Notes • Make sure not to use the wireless LAN function where medical equipment (such as a pacemaker) is used or where the use of wireless communication is prohibited. • Before connecting to your home network, you need to prepare a wireless LAN router/access point. For details, refer to the operating instructions of the device. • Depending on your home network environment, the wireless LAN router/access point may have been set up such that it cannot be connected using WPS, even though it is compatible with WPS. For details on whether your wireless LAN router/ access point is compatible or not compatible with WPS, and on the setup of a WPS connection, refer to the operating instructions of your wireless LAN router/access point. • You may encounter setup difficulties if the receiver and the wireless LAN router/access point are located too far from each other. If you do, move the devices closer to each other.