Sony STR-DN1030 Operating Instructions (Large File - 11.51 MB) - Page 20
Function for conversion of video signals, Notes on converting video, signals, To connect a recording - a v receiver
View all Sony STR-DN1030 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 20 highlights
Function for conversion of video signals The receiver is equipped with a function for converting video signals. Video signals and component video signals can be output as HDMI video signals (HDMI TV OUT jack only). As the default setting, video signals input from the connected equipment are output as shown in the table with solid arrows. INPUT jack OUTPUT jack HDMI IN HDMI TV OUT COMPONENT VIDEO IN COMPONENT VIDEO MONITOR OUT VIDEO IN MONITOR VIDEO OUT : Same type of signal as that of the input signal is output. : Video signals are upconverted and output (up to 1080i). Notes on converting video signals • When video signals from a VCR, etc., are up converted on this receiver and then viewed on your TV, depending on the status of the video signal output, the image on the TV screen may appear distorted horizontally or no image can be seen. • If you are using an image improvement circuitry with your VCR, it may impact the video signal conversion. It is recommended to turn off this function on your VCR. • Converted HDMI image output does not support x.v.Color (x.v.Colour), Deep Color (Deep Colour) and 3D. • HDMI video signals cannot be converted to component video signals and video signals. To connect a recording equipment When recording, connect the recording equipment to the VIDEO OUT jacks of the receiver. Connect cords for input and output signals to the same type of jack, as VIDEO OUT jacks do not have an up-conversion function. Note Signals output from the HDMI TV OUT or MONITOR OUT jacks may not be recorded properly. 20US