Xerox 3100MFP/S Analog Telephone Adapter User Guide - Page 12

Sagem_Fax_ATA101S.book Page 8 Jeudi, 21. février 2008 5:09 17 • T.38: in this mode which is specifically adapted for fax transfers, the signals are demodulated and their digital data are encapsulated in IP packets. This mode increases reliability and considerably lowers bandwidth needs compared with the "pass through" mode. The Sagem Fax ATA 101S can support DTMF recognition, call transfer, putting on hold, VAD, etc. If need be, you can contact our support department "See Customer Information", page 17). AUTOMATIC INSTALLATION AND SETUP (VIA TFTP) To administer a large number of Sagem Fax ATA 101S, it is recommended to use the TFTP method. This mode allows a server to deploy firmware updating and setting up on the ATAs in the network. Note This method is recommended when installing and setting up more than 10 units. Installing the TFTP server You first have to install a TFTP server. • If you already have an existing TFTP server, you can use it to remotely deploy the settings of your ATA units. • If you do not have a TFTP server, you have to install one in your network before continuing. Creating CLI command files After installing your TFTP server, you have to create CLI command files. The server will load them into the ATAs which will then run them. You have to create at least three files. The first, so-called, entry file specifies the name of the up-to-date firmware (which the ATAs will download if need be), and the name of the setup file applicable to all the ATAs (see next paragraph). The example below is the content of an entry file called "TFTPEntry.txt": fw_filename = S3-SIP-PIT-1-26-355-1019.bin common_config = common_parameters.txt 8 Sagem Fax ATA 101S