Xerox 3100MFP/S Analog Telephone Adapter User Guide - Page 14

Sagem_Fax_ATA101S.book Page 10 Jeudi, 21. février 2008 5:09 17 For example, for the ATA with a MAC address 00:60:4c:99:99:99 there is a corresponding file "Sagem_00604c999999.txt", the content of which (below) specifies the settings of the SIP account (user name, password, etc.) likely to be used with this ATA: MACConfigversion = V1_01 sip/configphone 1 444719 -o -d Lecoq sip/configauth 1 444719 MySecretPassword save sip/register all These CLI command files must be in ASCII format. Note To create these ASCII files, contact Sagem Communications or your dealer to obtain the ATA's list of CLI commands. Loading files from the TFTP server After creating the command files, you have to connect the ATAs to your company's computer network. For this purpose, you have to use your ATA "WAN" port. Indeed, only this port has a DHCP client allowing the ATA to request an IP address from the DHCP server and also to receive the address from the TFTP server and the input filename. These must be defined at the DHCP server end, as options 66 and 67 respectively. Important Make sure not to use the ATA LAN port for the "automatic setup" mode, as you will encounter IP address conflicts. As soon as it is connected to the network, each ATA automatically downloads the input file. If this file specifies a new firmware, this firmware is then downloaded. If not, the ATA downloads its two setup files (the common file then the customized file) to run their CLI commands. 10 Sagem Fax ATA 101S