Xerox 6180N DocuSP 61xx version 3.6 - Operator Guide - Page 125

Stock Weight Capacity Type or condition Stock Size Weight Capacity Technical information Table 7-6. Satisfaction guide for paper tray 3 Reliable feeds may be expected Less reliable feeds may be expected Suggested alternatives Substance 16 to 110 (60 to 200 g/m2) Weights outside the limits shown are not recommended. Substance 110 (200 g/m2) must be long grain except 17 x 11 inch (432 x 279 mm) substance 110 (200 g/m2) which must be short grain. 2600 sheets, substance 20 (75 g/m2) Xerographic bond paper in good condition Drilled stock, fanned thoroughly Slightly curled paper Intermixed weights Xerox vellum Full cut tabs Do not use excessively curled paper Substance 110 (200 g/m2) must be long grain. Do not use short grain. Label stock Precut tabs - use tray 1 or 2. Adhesive drafting film Paper with reinforced edges Transparencies with a white stripe, use tray 1 or 2. Freshly printed offset prints, use tray 3. Refer to the "Using various stocks" section for any stock not defined in this guide. Table 7-7. Satisfaction guide for paper tray 4 Reliable feeds may be expected Less reliable feeds may be expected Suggested alternatives 8 x 10 inches to 17 x 11 inches (203 x 254 mm to 432 x 279 mm) Smaller or larger sizes cannot be used. Substance 16 to 110 (60 to 200 g/m2) Weights outside the limits shown are not recommended. Substance 110 (200 g/m2) must be long grain except 17 x 11 inch (432 x 279 mm) substance 110 (200 g/m2) which must be short grain. 550 sheets, substance 20 (75 g/m2) DocuTech 61xx Operator Guide 7-9