Xerox 6180N DocuSP 61xx version 3.6 - Operator Guide - Page 49
Cleaning the binder
UPC - 095205425307
View all Xerox 6180N manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 49 highlights
Routine maintenance • Always use a drop cloth when replacing the dry ink cartridge, dry ink waste container, or when adding fuser agent. • Some parts of the system, such as the fuser, get hot during operation. To ensure that you do not burn yourself, be careful when working around these parts. WARNING The fuser can reach a temperature of approximately 425°F (218°C). Exercise care to prevent burns when working near this area. • To prevent injury to yourself, always use special care when using the wire cutters. WARNING All areas of the binder drawer, including the binder tape, are approximately 425°F (218°C) and may cause a serious burn to the operator. If the binder has been in a "Ready" condition, allow the binder to cool for at least one hour before attempting to clean the binder. Cleaning the binder Keep the binder clean to prevent binder tape jams. Clean the binder once a week, or as needed, and also when changing the binder tape. It is highly recommended that the binder be cleaned before the binder warm-up cycle begins or before switching the system on. The following steps must be performed to clean the binder. WARNING All areas of the binder drawer, including the binder tape, are hot, approximately 425°F (218°C), and may cause a serious burn. If the binder has been in a "Ready" condition, allow the binder to cool for at least one hour before continuing the procedure. 1. Open the finisher doors. DocuTech 61xx Operator Guide 5-7