Xerox 6180N DocuSP 61xx version 3.6 - Operator Guide - Page 127

Stock Weight Type or condition Technical information Table 7-9. Satisfaction guide for 2-sided printing Reliable feeds may be expected Less reliable feeds may be expected Suggested alternatives Substance 16 to 110 (60 to 200 g/m2) Substance 110 (200 g/m2) must be long grain. Weights outside the limits shown are not recommended. Xerographic bond paper in good condition Drilled stock, fanned thoroughly Slightly curled paper Paper with reinforced edges Do not use excessively curled paper Refer to the "Using various stocks" section for any stock not defined in this guide. Using various stocks The following table lists stock that have been evaluated and tested for use in this system. There are many other stocks available, some of which may not provide the same degree of user satisfaction. Refer to the "Using non-standard stock" section in this guide. Table 7-10. Satisfaction guide for various stocks Stock type Instructions for use Substance 13 (49 g/m2) paper Use trays 3,4,or 5. Do not run 2-sided prints. Load the paper with seam side down into tray 3. Optimum satisfaction can be expected with 8.5 x 11 inch (216 x 279 mm) or larger paper. Substance 16 (60 g/m2) Load paper with seam side up into trays 1 and 2; paper seam side down into tray 3, 4, or 5. Optimum satisfaction can be expected from tray 3, 4, or 5. Substance 20 (75 g/m2) Load the paper with seam side up into trays 1 paper and 2; seam side down into trays 3, 4, and 5. Card stock Card stock can be run from any tray. Xerox substance 65 (176 g/m2) Substance 110 (200 g/m2) long grain (index) Reduce set size if frequent paper jams or bindexer jams occur. If collated unfinished, another solution is to lower the value of the bindexer capacity set in the SWITCHES mode. DocuTech 61xx Operator Guide 7-11