Xerox 6180N DocuSP 61xx version 3.6 - Operator Guide - Page 129

Technical information Table 7-10. Satisfaction guide for various stocks Stock type Instructions for use Preprinted stock Preprinted forms must be made up of ink that has the following characteristics: • Can withstand temperatures up to 400°F (204°C) • Can withstand pressure of 140 psi at the above temperature • Can withstand the above conditions for 25 milliseconds High speed Load the stock with the stripe to the right in trays transparencies with white 1 and 2. stripe Label stock Load the stock face up into trays 1 and 2; face down into trays 3, 4, and 5. Do not select 2-sided prints. Letterhead (preprinted) Load the paper into trays 3, 4, and 5; side 1 with the printed side down, top edge to the front of the tray. Load the paper into trays 1 and 2; side 1 up with the top edge to the front of the tray. Do not use freshly preprinted paper in trays 1 and 2. Textured paper Heavily textured paper may produce prints with a ragged character appearance or deletions. To test, run a proof print. Window stock Run if the window is 2.2 to 4 inches (57 to 102 mm) from the top edge of the paper and at least 1 inch (25.4 mm) from each side of the paper. Run only as the first page or a front cover to avoid finisher bin jams. Load the window stock face-up into a tray (tray 1 or 2 is recommended) with the top edge toward the front of the tray. If running plastic-covered window stock, there may be some distortion. To test, run a proof copy. Xerox Carbonless Xerox Carbonless Paper is recommended. Do not use the following stocks: • Multipart forms • Stocks outside of the recommended size and weight ranges DocuTech 61xx Operator Guide 7-13