Xerox 6180N DocuSP 61xx version 3.6 - Operator Guide - Page 126

Technical information Stock Type or condition Stock Size Weight Capacity Type or condition Stock Size Table 7-7. Satisfaction guide for paper tray 4 Reliable feeds may be expected Less reliable feeds may be expected Suggested alternatives Xerographic bond paper in good condition Drilled stock, fanned thoroughly Slightly curled paper Intermixed weights Xerox vellum Full cut tabs Do not use excessively curled paper Substance 110 (200 g/m2) must be long grain. Do not use short grain. Label stock Adhesive drafting film Paper with reinforced edges Refer to the "Using various stocks" section for any stock not defined in this guide. Table 7-8. Satisfaction guide for paper tray 5 Reliable feeds may be expected Less reliable feeds may be expected Suggested alternatives 8 x 10 inches to 17 x 11 inches (203 x 254 mm to 432 x 279 mm) Smaller or larger sizes cannot be used. Substance 16 to 110 (60 to 200 g/m2) Weights outside the limits shown are not recommended. Substance 110 (200 g/m2) must be long grain except 17 x 11 inch (432 x 279 mm) substance 110 (200 g/m2) which must be short grain. 2600 sheets, substance 20 (75 g/m2) Xerographic bond paper in good condition Drilled stock, fanned thoroughly Slightly curled paper Intermixed weights Xerox vellum Full cut tabs Do not use excessively curled paper Substance 110 (200 g/m2) must be long grain. Do not use short grain. Label stock Adhesive drafting film Paper with reinforced edges Refer to the "Using various stocks" section for any stock not defined in this guide. Table 7-9. Satisfaction guide for 2-sided printing Reliable feeds may be expected Less reliable feeds may be expected Suggested alternatives 8 x 10 inches to 17 x 11 inches (203 x 254 mm to 432 x 279 mm) 17 x 11 inch (432 x 279 mm) paper can only be sent to the top tray. 7-10 DocuTech 61xx Operator Guide