Yamaha N12 Owners Manual - Page 43
Mixing recorded tracks, Mixing audio tracks - compressor
UPC - 086792859866
View all Yamaha N12 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 43 highlights
STEREO BUS English Using the n8/n12 with Cubase 4/Cubase Studio 4/Cubase AI 4 Mixing recorded tracks You can easily monitor tracks recorded in Cubase by mixing them on Cubase and setting the n8/n12's C-R SOURCE SELECT switch to DAW. If you wish to use the n8/n12's compressor and reverb, you can mix tracks using the n8/n12. This section describes how to send recorded audio track data from Cubase to the n8/n12 input channels, and then mix them to stereo. Mixing audio tracks 1. If the Monitor Remote function is enabled, turn the MONITOR REMOTE [ON] switch off to disable the Monitor Remote function. 2. If any audio tracks' Record Enable buttons are on, turn these buttons off. 3. Set the STEREO fader to the "0" position, then make sure that the STEREO [ON] switch is turned on. 4. Turn on the [HARDWARE MIX] switch in the DAW Remote Control section (the switch LED lights up). When the switch is turned on, the input source for all input channels is switched to DAW (Cubase audio tracks). The Cubase audio track signals will be input at the point immediately after the A/D converter in each input channel. ■ n12 Cubase track # Output to (n12 input channel) Track 1 n12-1 Track 2 n12-2 Track 3 n12-3 Track 4 n12-4 Track 5 n12-5 Track 6 n12-6 Track 7 n12-7 Track 8 n12-8 Track 9 n12-9/10 Track 10 and higher n12-11/12 ■12 Cubase AUDIO TRACK AUDIO TRACK INPUT CHANNEL PAN INPUT A/D COMP EQ INPUT CHANNEL n8/n12 Cubase track # Output to (n8 input channel) Track 1 n8-1 Track 2 n8-2 Track 3 n8-3 Track 4 n8-4 Track 5 n8-5/6 Track 6 and higher n8-7/8 NOTE While the Work mode is set to HARDWARE MIX, you can select analog inputs (A. IN) as the input source for the input channels. This is convenient if you wish to add analog input signals to the mix. 5. If necessary, click the audio track output routing menu, and change the output destination. When you set the Work mode to HARDWARE MIX, the audio track outputs will be assigned to channels in the order of their track number. track numbers audio track output destination (Output Routing) Owner's Manual 43