Yamaha N12 Owners Manual - Page 44

Using the n8/n12 with Cubase 4/Cubase Studio 4/Cubase AI 4 Use one of the following three methods to route Cubase audio tracks to the n8/n12. ■ Assign each audio track to an input channel individually This method is useful when you want to mix a solo part or other important parts. Cubase AUDIO TRACK AUDIO TRACK n8/n12 INPUT CHANNEL INPUT CHANNEL In the Cubase mixer, adjust the mix balance between the tracks. 7. While playing back the Cubase project, control the channel faders to adjust the mix balance. If the signals are being mixed to the STEREO buses via DAW TO ST, rotate the DAW TO ST [LEVEL] control to adjust the signal level. You can also apply the n8/n12 built-in digital reverb to the audio track playback signal by turning on the REVERB TO ST [ON] switch and rotating the channel [REVERB] control. English ■ Assign multiple audio tracks to the same input channel In this case, multiple audio tracks will be mixed in the Cubase mixer, then routed to the n8/n12 input channel. This method is useful when you want to first create a mix from multiple tracks, such as drums recorded on multiple tracks. Cubase AUDIO TRACK AUDIO TRACK n8/n12 INPUT CHANNEL INPUT CHANNEL ■ Select the "n12 (n8)-L/R" output routing option, then mixing signals via DAW TO ST. If you turn the DAW TO ST [ON] switch on, you can use DAW TO ST as the input channel. STEREO BUS Cubase AUDIO TRACK AUDIO TRACK n8/n12 INPUT CHANNEL INPUT CHANNEL DAW TO ST on 6. Use the Cubase mixer control to adjust the output level of the audio tracks. ■ If you are assigning each audio track to an input channel individually: In the Cubase mixer, set the fader (for the track you wish to assign) to the "0.00" position. With this setting, the signal will be routed to the input channel at the nominal output level. ■ If you are assigning multiple audio tracks to the same input channel: 44 Owner's Manual