Yamaha RX-Z11 Owner's Manual - Page 104

Graphical user interface (GUI) menu ■ Parametric EQ (Parametric equalizer) Use this feature to adjust the parametric equalizer of each speaker. Dynamic Range S-Wave Control Parametric EQ Tone Control Lipsync Subwoofer L Subwoofer R Test Tone PEQ Data Copy PEQ Select PEQ Data Copy (Parametric equalizer data copy) Use this feature to copy the result data of the automatic setup to the manual configuration area. You can select the parametric equalizer type applied to the copied result data of the automatic setup. See page 50 for the descriptions of each parametric equalizer type. Choice Descriptions Flat → Manual Copies the result of the automatic setup that the "Flat" type parametric equalizer is applied to. Front → Manual Manual Copies the result of the automatic setup that the "Front" type parametric equalizer is applied to. Natural → Manual Copies the result of the automatic setup that the "Natural" type parametric equalizer is applied to. PEQ Select (Parametric equalizer type select) Use this feature to select the parametric equalizer type that applied to the results of the automatic setup. See page 50 for the descriptions of each parametric equalizer type. Choice Descriptions Manual Flat Applies the manually configured parametric equalizer in "Manual Setup". Applies the "Flat" type parametric equalizer. Front Applies the "Front" type parametric equalizer. Natural Applies the "Natural" type parametric equalizer. Through Does not use the parametric equalizer. Notes • When you carry out the automatic setup, this unit automatically set "PEQ Select" to "Natural". • "Speaker Level" settings (see page 102) also changes corresponding to the setting of "PEQ Select". • This unit does not change the configurations of "Manual" even if you perform the automatic setup. Manual parametric equalizer configuration of each speaker Use this feature to adjust the tonal quality of each speaker. You can copy the results of the automatic setup for the base of the manual configuration by using "PEQ Data Copy". Set "PEQ Select" to "Manual" in advanced. 1 Press 9k / n / l / h to select "Test Tone" or the speaker you want to adjust. Choice Front L Front R Center Surround L Surround R Surround Back L Surround Back R Front Presence L Front Presence R Rear Presence L Rear Presence R Subwoofer L Subwoofer R Adjusted speaker Front left speaker Front right speaker Center speaker Surround left speaker Surround right speaker Surround back left speaker Surround back right speaker Front presence left speaker Front presence right speaker Rear presence left speaker Rear presence right speaker Subwoofer left Subwoofer right Test Tone Use this feature to select whether to turn on or off the test tone output while you are adjusting the tonal quality of each speaker. Choice On Off Functions Outputs the test tone. Does not output the test tone. 2 Press 9h to access the settings window. PEQ Data Copy PEQ Select Front L Front R Center PARAM RESET EDIT EXIT Band/Gain 3 Press 9k / n / l / h to select "PARAM" and then press 9ENTER to select a parameter from "Band" (band), "Freq." (frequency) or "Q" (Q factor). y You can adjust "Gain" (gain) with any parameter. 104 En