Yamaha RX-Z11 Owner's Manual - Page 167

Specifications Specifications AUDIO SECTION • Minimum RMS Output Power (20 Hz to 20 kHz, 0.04% THD, 8 Ω) Front, Center, Surround, Surround back 140 W Front presence, Rear presence 50 W • Dynamic Power (IHF) Front L/R 8/6/4/2 185/230/290/385 W • Dynamic Headroom 8 Ω ...1.2 dB • Damping Factor (IHF) Front L/R 1 kHz, 8 150 or more • Input Sensitivity/Input Impedance PHONO 3.5 mV/47 kΩ CD, etc 200 mV/47 kΩ MULTI CH INPUT 200 mV/47 kΩ • Maximum Input Voltage PHONO (1 kHz, 0.1% THD 60 mV or more CD, etc. (1 kHz, 0.5% THD 2.4 V or more • Rated Output Voltage/Output Impedance AUDIO OUT 200 mV/900 Ω PRE OUT 1.0 V/500 Ω SUBWOOFER 2.0 V/500 Ω ZONE OUT 1.0 V/1.4 kΩ • Headphone Jack Rated Output/Impedance CD, etc. (1 kHz, 40 mV, 8 150 mV/100 Ω • Frequency Response CD to Front L/R, Pure Direct 10 Hz to 100 kHz, +0/-3 dB • RIAA Equalization Deviation PHONO (20 Hz to 20 kHz 0 ± 0.5 dB • Total Harmonic Distortion PHONO to AUDIO OUT (20 Hz to 20 kHz, 1 V 0.02% or less CD, etc. to Front L/R (20 Hz to 20 kHz, 70 W, 8 0.02% or less • Signal to Noise Ratio (IHF-A Network) PHONO (2.5 mV) to Front L/R [U.S.A. and Canada models 80 dB or more PHONO (5 mV) to Front L/R [Australia model 81 dB or more [Other models 86 dB or more CD, etc. (250 mV) to Front L/R 100 dB or more • Residual Noise (IHF-A Network) Front L/R 70 µV or less • Channel Separation (1 kHz/10 kHz) PHONO (shortened) to Front L/R 70 dB/60 dB or more CD, etc. (5.1 kΩ shortened) to Front L/R 70 dB/60 dB or more • Tone Control (Front L/R, Center, Subwoofer) BASS Boost/Cut 6 dB/50 Hz BASS Turnover Frequency 350 Hz TREBLE Boost/Cut 6 dB/20 kHz TREBLE Turnover Frequency 3.5 kHz • Zone 2/Zone 3 Tone Control BASS Boost/Cut 10 dB/100 Hz BASS Turnover Frequency 380 Hz TREBLE Boost/Cut 10 dB/10 kHz TREBLE Turnover Frequency 1.6 kHz • Filter Characteristics (fc=40/60/80/90/100/110/120/160/200 Hz) H.P.F. (Front, Center, Surround, Surround Back: Small 12 dB/oct. L.P.F. (Subwoofer 24 dB/oct. VIDEO SECTION • Video Format [MONITOR OUT] (Wall Paper) [U.S.A. and Canada models NTSC/PAL [Australia model PAL/NTSC • Video Format (Video Conversion NTSC/PAL • Signal Level Composite 1 Vp-p/75 Ω S-video 1 Vp-p/75 Ω (Y), 0.286 or 0.3 Vp-p/75 Ω (C) Component 1 Vp-p/75 Ω (Y), 0.7 Vp-p/75 Ω (PB/PR) Maximum Input Level (Video Conversion Off 1.5 Vp-p or more • Signal to Noise Ratio (Video Conversion Off 70 dB or more • Frequency Response [MONITOR OUT] Component (Video Conversion Off 5 Hz to 100 MHz, ±3 dB • Video Format [ZONE OUT] (Gray Back) [U.S.A. and Canada models NTSC/PAL [Australia model PAL/NTSC • Video signal type [ZONE COMPONENT OUT] (Video conversion NTSC/PAL FM SECTION • Tuning Range [U.S.A. and Canada models 87.5 to 107.9 MHz [Australia model 87.50 to 108.00 MHz • 50 dB Quieting Sensitivity (IHF) Mono/Stereo 2.0/25 µV (17.3/39.2 dBf) • Usable Sensitivity (IHF 1.0 µV (11.2 dBf) • Selectivity (400 kHz 70 dB • Signal to Noise Ratio (IHF) Mono/Stereo 76 dB/70 dB • Harmonic Distortion (1 kHz) Mono/Stereo 0.2/0.3% • Stereo Separation (1 kHz) Stereo ...40 dB • Frequency Response Stereo 20 Hz to 15 kHz, +0.5, -2 dB • Antenna Input (unbalanced 75 Ω AM SECTION • Tuning Range [U.S.A. and Canada models 530 to 1710 kHz [Australia model 531 to 1611 kHz • Usable Sensitivity 300 µV/m • Antenna Loop antenna GENERAL • Power Supply [U.S.A. and Canada models AC 120 V, 60 Hz [Australia model AC 240 V, 50 Hz • Power Consumption 800 W/1000 VA • Standby Power Consumption 0.1 W or less • AC Outlets [U.S.A. and Canada models 2 (Total 100 W/0.8 A maximum) [Australia model 1 (100 W maximum) • Dimensions (W x H x D 435 x 210 x 497 mm (17-1/8 x 8-1/4 x 19-9/16 in) • Weight 34.0 kg (74.0 lbs 15 oz) * Specifications are subject to change without notice. Additional Information 167 En