Yamaha RX-Z11 Owner's Manual - Page 138

Using multi-zone configuration ■ Using REMOTE IN/OUT and TRIGGER OUT jacks for Zone 2, Zone 3, and Zone 4 You can use the REMOTE IN/OUT and TRIGGER OUT jacks of this unit for Zone 2, Zone 3, and Zone 4 as well as the main zone. Refer to "Using REMOTE IN/OUT jacks" and "Using the TRIGGER OUT jacks" on page 38 for more information. REMOTE IN/OUT jacks This unit is equipped with two REMOTE IN and REMOTE OUT jacks. You can use the REMOTE IN/OUT jacks to control this unit or other component from Zone 2, Zone 3, or Zone 4. The following diagram shows an example of the connections. DVD player (etc.) Remote control signal in This unit REMOTE 1 IN 2 1 OUT 2 REMOTE IN 1 OUT Remote control signal out External amplifier Remote control Zone 2 IN 2 Remote control OUT CD player (etc.) signal in Remote control signal out Remote control Infrared signal receiver Zone 3 y Some Yamaha models are able to connect directly to the REMOTE OUT jack on this unit. If you own these products, you may not need to use an infrared emitter. Up to six Yamaha components can be connected as shown. REMOTE IN REMOTE OUT IN REMOTE OUT IN REMOTE OUT Infrared signal receiver This unit Yamaha component Yamaha component TRIGGER OUT jacks This unit is equipped with two TRIGGER OUT jacks. You can turn on and off the component corresponding to the selection of the input source of the desired zone or turning on and off the desired zone. Use "Trigger Output" in "Manual Setup" to set the functions of the TRIGGER OUT jacks (see page 114). This unit TRIGGER Trigger in OUT 1 2 Power amplifier (etc.) Zone 2 (etc.) TRIGGER OUT 1 2 Trigger in Projector (etc.) in the main zone 138 En