Acer G540-E5405 Altos G540 User's Guide EN - Page 57
To install an easy-swap hard drive, SAS1-1 connector of the SAS controller board.
UPC - 750519186893
View all Acer G540-E5405 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 57 highlights
47 To install an easy-swap hard drive: 1 Remove the side panel from the chassis. Go to page 39 for instructions. 2 Observe steps 2 through 5 of the previous section. 3 Connect the easy-swap HDD cables. (1) Connect the power connectors of the SAS/SATA2 cable to the power supply module HDD power cables. (2) Connect the data connectors of the SAS/SATA2 cable to the signal connectors of the of the easy-swap HDDs. (3) Connect the other end of the SAS/SATA2 power cable to the SAS1-1 connector of the SAS controller board. 4 Observe the post-installation instructions described on page 38. 5 Set up the new hard drive's RAID configuration. For related instructions, go to the "RAID configuration utilities" section on page 114.
47
To install an easy-swap hard drive:
1
Remove the side panel from the chassis.
Go to page 39 for instructions.
2
Observe steps 2 through 5 of the previous section.
3
Connect the easy-swap HDD cables.
(1)
Connect the power connectors of the SAS/SATA2 cable to the
power supply module HDD power cables.
(2)
Connect the data connectors of the SAS/SATA2 cable to the
signal connectors of the of the easy-swap HDDs.
(3)
Connect the other end of the SAS/SATA2 power cable to the
SAS1-1 connector of the SAS controller board.
4
Observe the post-installation instructions described on page 38.
5
Set up the new hard drive’s RAID configuration.
For related instructions, go to the “RAID configuration utilities”
section on page 114.