Autodesk 057A1-05A111-1001 Getting Started Guide - Page 109
Trim the large circle as shown below.
UPC - 606122219674
View all Autodesk 057A1-05A111-1001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 109 highlights
5 Create a circle using the tangent-tangent-radius (Ttr) option. The radius should be 250 mm. Notice that the AutoSnap marker for tangent is turned on automatically. Command: circle Specify center point for circle or [3P/2P/Ttr (tan tan radius)]: t Specify point on object for first tangent of circle: Select an outer circle near the expected tangent location Specify point on object for second tangent of circle: Select the other outer circle as shown Specify radius of circle: 250 (only part of the circle is shown in the illustration) 6 Trim the large circle as shown below. Fillet Corners | 103
Fillet Corners
|
103
5
Create a circle using the tangent-tangent-radius (Ttr) option. The radius should be 250 mm.
Notice that the AutoSnap marker for tangent is turned on automatically.
Command: circle
Specify center point for circle or [3P/2P/Ttr (tan tan radius)]:
t
Specify point on object for first tangent of circle:
Select an outer circle near the expected tangent location
Specify point on object for second tangent of circle:
Select the other outer circle as shown
Specify radius of circle:
250
(only part of the circle is shown in the illustration)
6
Trim the large circle as shown below.