Autodesk 057A1-05A111-1001 Getting Started Guide - Page 95
Try it: Trim an object
UPC - 606122219674
View all Autodesk 057A1-05A111-1001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 95 highlights
Try it: Trim an object 1 Create two horizontal lines and two vertical lines as shown in the left side of the previous illustration. You can use the Perpendicular object snap to make sure that the two horizontal lines intersect the vertical line at a right angle. 2 Click Menu Browser ➤ Modify ➤ Trim. 3 At the Select Objects prompt, click locations 1 and 2 as previously illustrated. Notice that you select the boundary objects first. 4 Press ENTER to end boundary selection. 5 At the next Select Objects prompt, click the vertical line at point 3 as shown. Press ENTER to end the command. NOTE With both EXTEND and TRIM, you must accept the selection set of boundary objects by pressing ENTER, and then select the objects to be trimmed. If you press ENTER without selecting any boundary objects, all objects become potential boundaries. Erase, Extend, and Trim Objects | 89