Autodesk 057A1-05A111-1001 Getting Started Guide - Page 111
Trim the four vertical lines representing the silhouette edges of the holes as shown. Don't forget
UPC - 606122219674
View all Autodesk 057A1-05A111-1001 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 111 highlights
3 Use the Endpoint object snap to create a line connecting the upper ends of the vertical lines. 4 Offset the horizontal line downward by 12 mm. 5 Trim the lower ends of the vertical lines to create the rectangular outline of the top view. 6 Offset the topmost horizontal line upward by 3 mm. Create vertical lines from the quadrants of the other circles as shown. 7 Trim the four vertical lines representing the silhouette edges of the holes as shown. Don't forget to press ENTER after selecting the horizontal boundary line for the trimming. boundary line for trim 8 Trim the other vertical lines as shown. Zoom and pan as needed. Fillet Corners | 105
Fillet Corners
|
105
3
Use the Endpoint object snap to create a line connecting the upper ends of the vertical lines.
4
Offset the horizontal line downward by 12 mm.
5
Trim the lower ends of the vertical lines to create the rectangular outline of the top view.
6
Offset the topmost horizontal line upward by 3 mm. Create vertical lines from the quadrants of
the other circles as shown.
7
Trim the four vertical lines representing the silhouette edges of the holes as shown. Don’t forget
to press ENTER after selecting the horizontal boundary line for the trimming.
8
Trim the other vertical lines as shown. Zoom and pan as needed.
boundary line
for trim