Brother International HL-3400CN Users Manual - English - Page 210

CHAPTER 5 MAINTENANCE 3. Select the font with the Font button. See "FONT button" in Chapter 4. Network Option Modular I/O Card Before installing an NC-2010h/2100h Network card, please note the following information. Before NC-2010h/2100h Installation (USA) When you install the NC-2010h/2100h Ethernet interface card, this printer complies with the limits for a Class A digital device, pursuant to Part 15 of the FCC Rules. Please refer to the NC-2010h/2100h User's Guide for the FCC notice. (CANADA) When you install the NC-2010h/2100h Ethernet interface card, this printer complies with the limits for a Class A digital apparatus, pursuant to Canadian Interference-Causing Equipment Regulations. (Europe) When you install the NC-2010h/2100h Ethernet interface card, this printer complies with EN 55022 Class A. Warning In a domestic environment, the printer used with an NC-2010h/2100h Network card may cause radio interference, in which case the user may be required to take adequate measures to prevent any such interference. This printer has a modular input/output (MIO) interface slot on the rear panel. This slot allows you to install a commercial MIO-compatible sharing/network card. For more information about MIO cards, consult the dealer where you purchased this printer. Because the NC-3100h is installed on this printer, you have to remove the NC-3100h first to install an MIO card. When you install the MIO card, follow these steps: 1. Turn off the printer and unplug the power cord from the wall socket.  Note • Be sure to turn off the power to the printer before installing or removing the MIO card. • Be sure to remove the interface cable connector when installing the MIO card. 5-53