Brother International HL-3400CN Users Manual - English - Page 213

USER'S GUIDE 9. Retain the cover plate and two screws removed in Step 2 in case you want to remove the MIO card later. Fig. 5-72 Installing the MIO Card RAM Expansion This printer has 64 Mbytes of memory standard and 2 slots for optional expansion memory. The memory can be expanded up to 320 Mbytes by installing commercially available dual in-line memory modules (DIMMs). (The standard memory fitted can vary depending on the printer model and country.) This printer uses memory module which is: 100 pins, no-parity, SDRAM with 64Mbit or more. This printer is not compatible with Extended Data Output (EDO) DIMM, or DIMM which uses 16Mbit SDRAM. The following capacity of DIMM can be installed: • 16 Mbyte TECHWORKS PM-HP 16M-BR • 32 Mbyte TECHWORKS PM-HP 32M-BR • 64 Mbyte TECHWORKS PM-HP 64M-BR • 128 Mbyte TECHWORKS PM-HP 128M-BR In general, the DIMM must have the following specifications: Type: 100 pin and 32 bit output CAS Latency: 2 or 3 Clock Frequency: 66Mhz or more Capacity: 16,32, 64 or 128 Mbyte Height: 46mm (1.8 inches) or less Parity: NONE Dram Type: 64 M bit SDRAM 4 Bank SDRAM can be used.  Notes • There might be some DIMMs which will not work with this printer. • For more informationabout the memory cards consult the dealer where you purchased the printer. • For the latest information: http://www.brother.com 5-56