Cisco 6513 Installation Guide - Page 203
Connecting Transceivers to a Copper Network, Verifying the Installation
![]() |
View all Cisco 6513 manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 203 highlights
Chapter 3 Installing Ethernet Switching Modules Verifying the Installation Connecting Transceivers to a Copper Network Caution To comply with GR-1089 intrabuilding lightning immunity requirements, you must use grounded, shielded, twisted-pair Category 5 cabling. To connect transceivers to a copper network, follow these steps: Step 1 Insert the network cable RJ-45 connector into the RJ-45 connector on the transceiver. Note When connecting to a 1000BASE-T-compatible switch or repeater, use four-twisted-pair, crossover Category 5 cabling. Step 2 Insert the other end of the network cable into an RJ-45 connector on a 1000BASE-T-compatible target device. Verifying the Installation This section describes how to verify the installation of a supervisor engine or switching module. To verify the installation of a Catalyst 6500 series switch running Cisco IOS software, see the Catalyst 6500 Series Switch IOS Software Configuration Guide. This section contains the following topics: • Verifying Newly Installed Modules, page 3-26 • Checking Connectivity, page 3-27 OL-6265-03 Catalyst 6500 Series Ethernet Modules Installation Guide 3-25
![](/manual_guide/products/cisco-6513-installation-guide-bb98e47/203.png)