Cisco IE-3000-8TC Installation Guide - Page 129
B-29, Torquing the Power and Relay Connector Captive Screws, Step 1
View all Cisco IE-3000-8TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 129 highlights
Appendix B Installation In a Hazardous Environment Connecting Power and Alarm Circuits Step 4 Use a ratcheting torque flathead screwdriver to torque the power and relay connector captive screw (above the installed wire leads) to 2 in-lb. See Figure B-29 for details. Caution Do not over-torque the power and relay connector captive screws. The torque should not exceed 2 in-lb. Figure B-29 Torquing the Power and Relay Connector Captive Screws 202030 V RT A A Step 5 Repeat Step 1 through Step 4 to insert the input and output wires of an additional external alarm device into the second power and relay connector. OL-13017-01 Cisco IE 3000 Switch Hardware Installation Guide B-39
B-39
Cisco IE 3000 Switch Hardware Installation Guide
OL-13017-01
Appendix B
Installation In a Hazardous Environment
Connecting Power and Alarm Circuits
Step 4
Use a ratcheting torque
flathead screwdriver to torque the power and relay connector captive screw
(above the installed wire leads) to 2 in-lb. See
Figure B-29
for details.
Caution
Do not over-torque the power and relay connector captive screws. The torque should not exceed 2 in-lb.
Figure B-29
Torquing the Power and Relay Connector Captive Screws
Step 5
Repeat
Step 1
through
Step 4
to insert the input and output wires of an additional external alarm device
into the second power and relay connector.
202030
RT
A
V
A