Cisco IE-3000-8TC Installation Guide - Page 143
Connecting the Power Converter to an AC Power Source, Preparing the AC Power Cord, B-53
View all Cisco IE-3000-8TC manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 143 highlights
Appendix B Installation In a Hazardous Environment Connecting the Switch to the Power Converter Figure B-41 1 Connecting Wires to the Power Converter DC Output Terminal Block 2 3 5 1 6 2 7 1 3 8 2 4 CONSOLE 202298 1 DC power clip 3 Four-pin connector on the switch 2 Two-pin connector on the power convertor Step 3 Use a ratcheting torque flathead screwdriver to tighten the captive screw to 2 in-lb. Caution Do not over-torque the power and relay connector captive screws. The torque should not exceed 2 in-lb. Connecting the Power Converter to an AC Power Source These sections describe the steps required to connect the power converter to an AC power source: • Preparing the AC Power Cord, page B-53 • Connecting the AC Power Cord to the Power Converter, page B-54 Preparing the AC Power Cord To connect the power converter to an AC power source, you need a standard 18-gauge, unterminated AC power cord. See Figure B-42. Power cord connector types vary by country. Power-cord color codes also vary by country. See Table 2-2. Note Use copper conductors only, rated at a minimum temperature of 167°F (75°C). OL-13017-01 Cisco IE 3000 Switch Hardware Installation Guide B-53