Dell Force10 E1200i Installing and Maintaining the E1200i System - Page 73
interface management port config show, config show
View all Dell Force10 E1200i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 73 highlights
Step Command Task (continued) 6 interface management port config 100m interface management port config 10m interface management port config auto-negotiate interface management port config no auto-negotiate interface management port config full-duplex interface management port config half-duplex interface management port config show • (OPTIONAL) Use these commands to set the speed and duplex settings for the Management interface.The default setting is full-duplex and autonegotiation. • Use the interface management port config show command to view the Management interface's physical settings. 7 show interface management ethernet • Use the show interface management ethernet command to display the IP address and network mask of the management Ethernet port. interface management ethernet ip address ip-address ip-addressmask • If the show command output does not display configured IP address information, use the interface management ethernet ip address ip-address ip-address-mask command to set the IP address of the Management Ethernet port for network (ftp/tftp) operating system boot. BOOT_USER # show interface management ethernet No IP address set for interface management ethernet 0/0! BOOT_USER # interface management ethernet ip address 1.2.3.4 255.255.0.0 Management ethernet 0/0 IP address: 1.2.3.4 255.255.0.0 8 show default-gateway default-gateway ip-address (Optional) Use the show default-gateway command to view gateway information. If your server is on the same subnet, you do not need to configure a gateway parameter. If your server is not on the same subnet, use the default-gateway ip-address command to set the gateway IP address. System Boot | 73