Dell PowerVault 56F Dell PowerVault 56F 16-Port Fibre Channel Switch Inst - Page 113
Removing a GBIC Module
View all Dell PowerVault 56F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 113 highlights
1. Inset the new fan assembly into the switch's front assembly cavity. 2. Tighten the four front thumb-screws. Replacing the system board involves removing the switch's cover, removing the system board, and installing the new system board. #6 flat-head screwdriver 1. Remove all cabling attached to the front panel. 2. Remove all GBICs. See "Removing a GBIC Module" found earlier in this chapter for instructions. 3. Disconnect the power supply connector(s). 4. Remove the system board module by loosening the captured screw located between ports 7 and 9 and pulling the assembly out of the switch. See Figure 6-5. 5. Remove the new system board from its antistatic bag and place the old system board into the bag. support.dell.com Repair and Replacement 6-5