Dell PowerVault 56F Dell PowerVault 56F 16-Port Fibre Channel Switch Inst - Page 26
NOTE: The switch meets International Electronic Commission IEC 801-5 surge volt
![]() |
View all Dell PowerVault 56F manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 26 highlights
Switch power connection is by way of a switched connector on the switch's front right side, as shown in Figure 1-1. The switch power requirements are as follows: Properly wired, grounded outlet Input voltage: 85-265 volts alternating current (VAC) Total power: Up to 155 watts (see Appendix A, "Specifications" in the User's Guide) Input line frequency: 47 to 63 hertz (Hz) The switch has an autoranging power supply that automatically accepts voltages within its ranges. power supply 2 (optional) power supply 1 NOTE: The switch meets International Electronic Commission (IEC) 801-5 surge voltage requirements; however, there is no other provision for surge protection built into the switch's power supplies. An installation should include normal provisions to ensure clean power. The switch should be installed in a secure or limited access site to control unauthorized access to the switch's cabling and power connections. NOTE: Do not block the front or back air vents. The switch must have clear access to ambient air for cooling. 1-2 Installation and Troubleshooting Guide
![](/manual_guide/products/dell-powervault-50f-dell-powervault-56f-16port-fibre-channel-switch-installation-troubleshooting-guide-a7ab90c/26.png)