Dell PowerVault 56F Dell PowerVault 56F 16-Port Fibre Channel Switch Inst - Page 92

lastUpTime downCount lastDownTime downReason iState Last time this interface came up. Number of times this interface went down Last time this interface went down Reason (SCN) for the interface going down The current interface state; it must be operational for the ISL to forward frames to the adjacent switch state nghbCap nghbId idbNo remPort inactTo helloTo rXmitTo nCmdAcc nInvCmd nHloIn nInvHlo The current state of the neighbor; its value must be NB_ST_FULL for the ISL to forward frames to the adjacent switch Neighbor capabilities; currently always 0 The domain ID of the neighbor (adjacent) switch The port number; it should be equal to ifNo The port number on the remote switch connected to this port The inactivity time out, in milliseconds (ms); when this timeout expires, the adjacency with the neighbor switch is considered broken; when that happens, new paths are computed to all the possible destination switches in the fabric The Hello timeout; when this timeout expires, a Hello frame is sent to the neighbor switch through this port The retransmit timeout; it is used to reliably transmit topology information to the neighbor switch; if an acknowledgment is not received within rXmitTo, a frame is retransmitted The total number of commands accepted from the neighbor switch; it includes Hellos, Link State Updates and Link State Acknowledges The number of invalid commands received from the neighbor switch; these are commands with a version higher than the one running on the local switch; the current version is 1 and there is no version 0 The number of Hello frames received from the neighbor switch The number of Hello frames with invalid parameters received from the neighbor switch 4-36 Installation and Troubleshooting Guide