Dell PowerVault 56F Dell PowerVault 56F 16-Port Fibre Channel Switch Inst - Page 152

DIAG-CMINOCAP [cmiTest] DIAG-CMISA1 [cmiTest] DIAG-CMNOBUF [centralMemoryTest] DIAG-DATA [portLoopbackTest, crossPortTest] DIAG-ERRSTAT [portLoopbackTest, crossPortTest, spinSilk] DIAG-INIT [portLoopbackTest, crossPortTest, spinSilk] DIAG-INTNIL [cmlTest] CMI intended receiver ASIC failed to get CMI capture flag ASIC or mainboard Replace main- failure board assembly An attempt to send a CMI mes- ASIC failure sage from ASIC to ASIC failed Replace mainboard assembly Port could not get any buffer ASIC failure Replace mainboard assembly Payload received by port did not match payload transmitted Mainboard, GBIC module or fiber cable failure Port Error Statistics counter is nonzero, meaning an error was detected when receiving frames. One of the following status errors occurred: Enc_In: Encoding error, inside frame CRC_err: Cyclic redundancy check on frame failed TruncFrm: Truncated frame FrmTooLong: Frame too long BadEOF: Bad end of file. Enc_out: Encoding error, outside frame BadOrdSet: Bad symbol on fiber-optic cable DiscC3: Discarded Class 3 frames Port failed to go active in the loopback mode requested ASIC, mainboard, GBIC module or fiber cable failure ASIC, mainboard, GBIC module or fiber cable failure ASIC failed to get a CMI error (interrupt) ASIC failure Replace mainboard assembly, GBIC module or fiber cable Replace mainboard assembly, GBIC module or fiber cable Replace mainboard assembly, GBIC module or fiber cable Replace mainboard assembly A-16 Installation and Troubleshooting Guide