Dell PowerVault 56F Dell PowerVault 56F 16-Port Fibre Channel Switch Inst - Page 151

DIAG-BUS_TIMEOUT [portRegTest, sramRetentionTest] DIAG-CAMINIT [camTest] DIAG-CAMSID [camTest] DIAG-CLEAR_ERR DIAG-SMBISRF [centralMemoryTest] DIAG-CMBISRTO [centralMemoryTest] DIAG-CMERRPTN [centralMemoryTest] DIAG-CMERRTYPE [centralMemoryTest] DIAG-CMICKSUM [cmiTest] DIAG-CMIDATA [cmiTest] DIAG-CMIINVCAP [cmiTest] ASIC register or ASIC SRAM did not respond to an ASIC data access ASIC failure Replace mainboard assembly Port failed to initialize due to one of the following reasons: Switch not disabled Diagnostic queue absent Malloc failed Chip is not present Port is not in loopback mode Port is not active ASIC failed SID NO translation test Software operational setup error or mainboard failure ASIC failure Retry, reboot or replace mainboard assembly Replace mainboard assembly Port's diag error flag (OK or BAD) is cleared ASIC's Central Memory SRAMS did not complete the BISR within the timeout period ASIC's Central Memory SRAMS did not complete the BISR within the timeout period Error detected at the wrong port Informational only ASIC failure ASIC failure ASIC failure None required Replace mainboard assembly Replace mainboard assembly Replace mainboard assembly Port got the wrong CMEM error type ASIC failure Replace mainboard assembly CMI message received failed bad checksum test ASIC or mainboard Replace main- failure board assembly CMI data received did not match date transmitted ASIC or mainboard Replace main- failure board assembly Unintended ASIC erroneously got CMI capture flag ASIC or mainboard Replace main- failure board assembly support.dell.com Error Messages A-15