Dell PowerVault MD3000i Command Line Interface Guide - Page 121

NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation. Example -c create host userLabel= \"job2900\";" Create Host Group This command creates a new host group. NOTE: A host group is an optional topological element that you can define to designate a collection of hosts that share access to the same virtual disks. The host group is a logical entity. Define a host group only if you have two or more hosts that can share access to the same virtual disks. Syntax create hostGroup userLabel="hostGroupName" Parameters Parameter userLabel Description Name to give the host group that you are creating. You must put quotation marks (" ") around the host group name. NOTE: You can use any combination of alphanumeric characters, hyphens, and underscores for the names. Command names can have a maximum of 30 characters. If you exceed the maximum character limit, replace square brackets ([ ]) with angle brackets (< >) to overcome this limitation. Create Host Port This command creates a new HBA host port identification. The identification is a software value that represents the physical HBA host port to the RAID controller module. Without the host port identification, the RAID controller module cannot receive instructions or data from the host port. Script Commands 121