Dell PowerVault MD3000i Command Line Interface Guide - Page 153
Re-create Snapshot, virtualDiskName, snapshotVirtualDiskName, percentValue
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 153 highlights
Parameter owner Description RAID controller module that owns the virtual disk. Valid RAID controller module identifiers are 0 or 1, where 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. If you do not specify an owner, the RAID controller module firmware determines the owner. For information about the owner parameter, see "Creating Virtual Disks with User-Assigned Physical Disks" on page 48. Re-create Snapshot This command starts a new copy-on-write operation by using an existing snapshot virtual disk. You can re-create a single snapshot virtual disk or recreate multiple virtual disks. NOTE: Refer to "Preparing Host Servers to Re-create a Snapshot Virtual Disk" on page 75. NOTICE: Before you create a new point-in-time image of a source virtual disk, stop any data access (I/O) activity or suspend data transfer to the source virtual disk to ensure that you capture an accurate point-in-time image of the source virtual disk. Close all applications, including Windows® Internet Explorer®, to make sure all I/O activity has stopped. NOTE: Removing the drive letter of the associated virtual disk in Windows or unmounting the virtual drive in Linux will help to guarantee a stable copy of the drive for the Snapshot. Syntax recreate snapshot (virtualDisk [virtualDiskName] | virtualDisks [virtualDiskName1 ... virtualDiskNamen]) [userLabel= "snapshotVirtualDiskName" warningThresholdPercent=percentValue repositoryFullPolicy=(failSourceWrites | failSnapShot)] Script Commands 153