Dell PowerVault MD3000i Command Line Interface Guide - Page 158
Reset Storage Array Battery Install Date, Reset Storage Array iSCSI Baseline
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 158 highlights
Parameters Parameter controller Description RAID controller module to reset. Valid RAID controller module identifiers are 0 or 1, where 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. You must put brackets ([ ]) around the RAID controller module identifier. If you do not specify an owner, the RAID controller module firmware returns a syntax error. Reset Storage Array Battery Install Date This command resets the age of the batteries in a storage array to zero days. You can reset the batteries for an entire storage array or the battery in a specific RAID controller module. Syntax reset storageArray batteryInstallDate controller= (0 | 1) Parameters Parameter controller Description Specifies the RAID controller module that contains the battery for which to reset the age. Valid RAID controller module identifiers are 0 or 1, where 0 is the controller in slot 0, and 1 is the controller in slot 1. NOTE: If you do not specify a RAID controller module, the age is reset for the storage array battery or both RAID controller module batteries. If you specify a RAID controller module, then the age for only that RAID controller module battery is reset. Reset Storage Array iSCSI Baseline This command resets the iSCI baseline for the storage array to 0. Syntax reset storageArray iscsiStatsBaseline 158 Script Commands