Dell PowerVault MD3000i Command Line Interface Guide - Page 87
Stopping a Virtual Disk Copy, Removing Copy Pairs
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 87 highlights
this command, you are copying the data from the source virtual disk to the target virtual disk. You are making this copy because the data on the source virtual disk changed since the previous copy was made. Refer to steps 1 through 4 in the preceding section, "Preparing Host Servers to Recopy a Virtual Disk" on page 85. The following example is the script file version of the command: recopy virtualDiskCopy target ["Obi_1"] copyPriority=highest; Stopping a Virtual Disk Copy The stop virtualDiskCopy command enables you to stop a virtual disk copy that has a status of In Progress, Pending, or Failed. After you stop a virtual disk copy, you can use the recopy virtualDiskCopy command to create a new virtual disk copy using the original virtual disk copy pair. All mapped hosts will have write access to the source virtual disk. The following syntax is the general form of the command: stop virtualDiskCopy target [targetName] [source [sourceName]] The following example shows a command to stop a virtual disk copy operation: client>smcli 123.45.67.89 -c "stop virtualDiskCopy target [\"Obi_1\"];" The following example is the script file version of the command: stop virtualDiskCopy target ["Obi_1"]; Removing Copy Pairs The remove virtualDiskCopy command enables you to remove a virtual disk copy pair from the storage array configuration. All virtual disk copy information for the source virtual disk and target virtual disk is removed from the storage array configuration. The data on the source virtual disk or target virtual disk is not deleted. Removing a virtual disk copy from the storage array configuration also removes the read-only attribute for the target virtual disk. Using the Virtual Disk Copy Feature 87