Dell PowerVault MD3000i Command Line Interface Guide - Page 170
Set Enclosure Attribute, enclosureID, userID
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 170 highlights
Parameter owner availability Description RAID controller module that owns the disk group. Valid RAID controller module identifiers are 0 or 1, where 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. Sets the disk group online or offline. NOTE: When using this command, you can specify one or more of the parameters. You do not, however, need to use all of the parameters. NOTE: Setting addPhysicalDisks or raidLevel starts a long operation that cannot be stopped. Set Enclosure Attribute This command sets user-defined attributes for an enclosure. Syntax set enclosure [enclosureID] (chassisName | assetTag)= "userID" Parameters Parameter enclosure chassisName Description Identifies a specific enclosure for which to set the attribute. Enclosure ID values are 0 to 99. You must put brackets ([ ]) around the enclosure ID value. Chassis name or number to give the new enclosure. Chassis names can be any combination of alphanumeric characters with a maximum length of 32 characters. Alphabetical characters can be uppercase or lowercase. You can also use the underscore character (_) and the hyphen (-) character. You cannot use spaces in a chassis name. You must put quotation marks (" ") around the chassis name. 170 Script Commands