Dell PowerVault MD3000i Command Line Interface Guide - Page 52

The userLabel, capacity, owner, and segmentSize parameters are the same as in the previous versions of the create virtualDisk command. Enclosure Loss Protection The enclosureLossProtect parameter is a boolean switch that turns enclosure loss protection on or off. To work properly, each physical disk in a virtual disk group must be in a separate enclosure. Enclosure loss protection is set under the following conditions: • You assign the physical disks. • The RAID controller module assigns the physical disks. The following table shows possible results for the enclosureLossProtect parameter. The results depend on whether you assign the physical disks or the RAID controller module assigns the physical disks. Method enclosureLossProtect= TRUE enclosureLossProtect=FALSE You assign the physical If you select more than one The storage array performs the disks. physical disk from any one operation, but the created disk enclosure, the storage array group does not have enclosure returns an error. loss protection. The RAID controller module firmware assigns the physical disks. The storage array posts an The storage array performs the error if the RAID controller operation even if it means that module firmware cannot the disk group might not have provide physical disks to enclosure loss protection. ensure that the new disk group has enclosure loss protection. The enclosureLossProtect parameter is not valid when creating virtual disks on existing disk groups. 52 Configuring a Storage Array