Dell PowerVault MD3000i Command Line Interface Guide - Page 164

Parameters Parameter allEvents | criticalEvents file count Description Specifies whether to save all events (allEvents) or only the critical events (criticalEvents). Name of the file to which to save the events. You must put quotation marks (" ") around the file name. Specifies the number of events or critical events to save to a file. If you do not enter a value for the count, all events or critical events are saved to the file. If you enter a value for the count, only that number of events or critical events (starting with the last event entered) are saved to the file. Use integer values. Save Storage Array iSCSI Statistics This command saves the storage array iSCSI performance statistics to a file. The following statistics are saved to the file: • Statistics related to the physical Ethernet port • Statistics related to the TCP protocol • Statistics related to the IP protocol Syntax save storageArray iscsiStatistics [raw | baseline] file="filename" Parameters Parameter Description raw This parameter defines that the statistics collected are all statistics from the RAID controller module start-of-day. Enclose the parameter in square brackets ([ ]). baseline This parameter defines that the statistics collected are all statistics from the time the RAID controller modules were reset to zero using the reset storageArray iscsiStatsBaseline command. Enclose the parameter in square brackets ([ ]). 164 Script Commands