Dell PowerVault MD3000i Command Line Interface Guide - Page 125
Auto Con Command on Enclosure Loss Protection
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 125 highlights
Parameter owner segmentSize enclosureLossProtect Description The RAID controller module that owns the virtual disk. Valid RAID controller module identifiers are 0 or 1, where 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. If you do not specify an owner, the RAID controller module firmware determines the owner. NOTE: The owner parameter defines which RAID controller module owns the virtual disk. If you do not specify a capacity, all of the available physical disk capacity in the disk group is used. If you do not specify capacity units, bytes are used as the default units. Amount of data (in kilobytes) that the RAID controller module writes on a single physical disk in a virtual disk before writing data on the next physical disk. Valid values are 8, 16, 32, 64, 128, 256, or 512. For information about the segmentSize parameter, see "Using the Auto Configure Command" on page 53. Specifies that enclosure loss protection is enforced when creating the disk group. To enforce enclosure loss protection, set this parameter to TRUE. The default setting is FALSE. For information about the enclosureLossProtect parameter, see "Enclosure Loss Protection" on page 52. Script Commands 125