Dell PowerVault MD3000i Command Line Interface Guide - Page 194
Set Virtual Disk Copy, Show Current iSCSI Sessions
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 194 highlights
Set Virtual Disk Copy This command defines the properties for a virtual disk copy pair. Syntax set virtualDiskCopy target [targetName] [source [sourceName]] copyPriority=(highest | high | medium | low | lowest) targetReadOnlyEnabled=(TRUE | FALSE) Parameters Parameter target source copyPriority targetReadOnlyEnabled Description Specifies the name of the target virtual disk for which to define properties. You must put brackets ([ ]) around the target virtual disk name. If the target virtual disk name has special characters, you must also put quotation marks (" ") around the target virtual disk name. Specifies the name of the source virtual disk for which to define properties. You must put brackets ([ ]) around the source virtual disk name. If the source virtual disk name has special characters, you must also put quotation marks (" ") around the source virtual disk name. Specifies the priority that the virtual disk copy has relative to host I/O activity. Valid entries are highest, high, medium, low, or lowest. Specifies whether the target virtual disk is write enabled or read only. To be able to write to the target virtual disk, set to FALSE. To prevent writing to the target virtual disk, set to TRUE. NOTE: When using this command, you can specify one or more of the parameters. You do not, however, need to use all of the parameters. Show Current iSCSI Sessions This command returns information about an iSCSI session. 194 Script Commands