Dell PowerVault MD3000i Command Line Interface Guide - Page 19
Table 1-2., Command Line Parameters, Parameter, Definition, script commands in a file are ignored
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 19 highlights
Table 1-2. Command Line Parameters (continued) Parameter -c Definition Use to indicate that you are entering one or more script commands to run on the specified storage array. Terminate each command by using a semicolon (;). -d -e -F (uppercase) -f (lowercase) You cannot place more than one -c parameter on the same command line. You can include more than one script command after the -c parameter. Use to display the contents of the script configuration file. Use to disable syntax checking when executing the current CLI command. Use to specify the email address from which all alerts will be sent. Use to specify a file name containing script commands intended to run on the specified storage array. This parameter is similar to the -c parameter in that both are intended for running script commands. The -c parameter allows you to execute individual script commands. The -f parameter allows you to execute script commands contained in a file. NOTE: By default, any errors encountered when running the script commands in a file are ignored, and the file continues to run. To override this behavior, use the set session errorAction=stop command in the script file. About the Command Line Interface 19