Dell PowerVault MD3000i Command Line Interface Guide - Page 38
parameter, the, configuration defaults to SAS physical
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 38 highlights
Table 2-4. Recurring Syntax Elements (continued) Recurring Syntax nvsram-offset host-type nvsram-byte-setting nvsram-bit-setting ipv4-address ipv6-address autoconfigure-vols-attr-value-list autoconfigure-vols-attr-value-pair Syntax Value hexadecimal-literal string-literal | integer-literal nvsram-value (0x hexadecimal | integer-literal) nvsram-mask, nvsram-value (0x hexadecimal, 0x hexadecimal | integer-literal) (0-255).(0-255).(0-255).(0-255) (0-FFFF):(0-FFFF):(0-FFFF): (0-FFFF):(0-FFFF):(0-FFFF): (0-FFFF):(0-FFF) autoconfigure-vols-attr-value-pair {autoconfigure-vols-attr-value-pair} physicalDiskType=physical disk-type| raidLevel=raid-level | diskGroupWidth=integer-literal | diskGroupCount=integer-literal | virtualDisksPerGroupCount=integerliteral| hotSpareCount=integer-literal | segmentSize=segment-size-spec NOTE: The physicalDiskType parameter is not required if only one type of physical disk is in the storage array. If you use the physicalDiskType parameter, you must also use the hotSpareCount and diskGroupWidth parameters. If you do not use the physicalDiskType parameter, the configuration defaults to SAS physical disks. NOTE: The virtualDisksPerGroupCount parameter is the number of equalcapacity virtual disks per disk group. 38 About the Script Commands