Dell PowerVault MD3000i Command Line Interface Guide - Page 142
you can optionally specify a file that, default pattern.
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 142 highlights
Parameters Parameter controller loopbackPhysicalDiskChannel Description RAID controller module on which to run the diagnostic tests. Valid RAID controller module identifiers are 0 or 1, where 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. You must put brackets ([ ]) around the RAID controller module identifier. If you do not specify a RAID controller module, the storage management software returns a syntax error. Physical disk channel on which to run the diagnostic tests. You can choose to run the diagnostics on all channels or select a specific channel on which to run diagnostics. Valid physical disk channel values are 1 or 2. NOTE: When you run a data loopback test, you can optionally specify a file that contains a data pattern. If you do not specify a file, the firmware provides a default pattern. 142 Script Commands