Dell PowerVault MD3000i Command Line Interface Guide - Page 202
Show Storage Array, storage array. You can enter the command with a single parameter or more
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 202 highlights
Parameters Parameter allControllers controller hostType host Description Returns information about both RAID controller modules in the storage array. Returns information about a specific RAID controller module in the storage array. Valid RAID controller module identifiers are 0 or 1, where 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the enclosure. You must put brackets ([ ]) around the RAID controller module identifier. Specifies the index label or number of the host type. Use the show storageArray hostTypeTable command to generate a list of available host type identifiers. Specifies the name of the host connected to the RAID controller modules. You must put quotation marks (" ") around the host name. NOTE: Use the show controller NVSRAM command to display parts or all of the NVSRAM before using the set controller command to change NVSRAM values. Show Storage Array This command returns configuration information about the storage array. The parameters return lists of values for the components and features in the storage array. You can enter the command with a single parameter or more than one parameter. If you enter the command with no parameters, the entire storage array profile is displayed (which is the same information as if you entered the profile parameter). Syntax show storageArray profile batteryAge connections defaultHostType healthStatus hostTypeTable hotSpareCoverage features time virtualDiskDistribution summary 202 Script Commands