Dell PowerVault MD3000i Command Line Interface Guide - Page 167
rloginEnabled=TRUE | FALSE, ethernet-port-options, nvsramOffset, nvsramByteSetting, hostType
View all Dell PowerVault MD3000i manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 167 highlights
Syntax set controller [(0 | 1)] availability=(online | offline | serviceMode) | bootp | ethernetPort [1] = ethernet-port-options globalNVSRAMByte [nvsramOffset]= (nvsramByteSetting | nvsramBitSetting) | hostNVSRAMByte [hostType, nvsramOffset]= (nvsramByteSetting | nvsramBitSetting) | iscsiHostPort [(1 | 2)] = iscsi-host-port-options rloginEnabled=(TRUE | FALSE) | serviceAllowedIndicator=(on | off) Parameters Parameter controller availability bootp ethernetPort Description This parameter is the RAID controller module for which you want to define properties. Valid identifiers for the RAID controller module are 0 or 1, where 0 is the RAID controller module on the left and 1 is the RAID controller module on the right when viewed from the rear of the RAID enclosure. You must put square brackets ([ ]) around the identifier for the RAID controller module. If you do not specify a RAID controller module, the firmware for the RAID controller module returns a syntax error. This parameter sets the mode for the RAID controller module to online, offline, or service (serviceMode). This parameter causes a RAID controller module to find a BOOTP server. The BOOTP server then assigns an IP address to the RAID controller module. This parameter defines the attributes (options) for the management Ethernet ports. Refer to Table 2-4 for a list of the attributes that you can set. Valid Ethernet port identifiers are 1 or 2. You must put square brackets ([ ]) around the Ethernet port identifier. Script Commands 167