Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 101
interface port-channel, interface range
![]() |
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 101 highlights
Supported Releases 10.3.0E or later interface port-channel Creates a port-channel interface. Syntax interface port-channel channel-id Parameters channel-id - Enter the port-channel ID number (1 to 128). Default Not configured Command Mode CONFIGURATION Usage Information The no version of this command deletes the interface. Example OS10(config)# interface port-channel 10 OS10(conf-if-po-10)# Supported Releases 10.2.0E or later interface range Configures a range of Ethernet, port-channel, or VLAN interfaces for bulk configuration. Syntax interface range {ethernet node/slot/port[:subport]-node/slot/port[:subport port-channel IDnumber-IDnumber,[ ...]} | vlan vlanID-vlanID,[...]} Parameters • node/slot/port[:subport]-node/slot/port[:subport] - Enter a range of Ethernet interfaces. • IDnumber-IDnumber - Enter a range of port-channel numbers (1 to 128). • vlanID-vlanID - Enter a range VLAN ID numbers (1 to 4094). Default Command Mode Usage Information Not configured CONFIGURATION Enter up to six comma-separated interface ranges without spaces between commas. When creating an interface range, interfaces are not sorted and appear in the order entered. You cannot mix interface configuration such as Ethernet ports with VLANs. • Bulk configuration is created if at least one interface is valid. • Non-existing interfaces are excluded from the bulk configuration with a warning message. • This command has multiple port ranges, the smaller port range is excluded from the prompt. • If you enter overlapping port ranges, the port range is extended to the smallest port and the largest end port. • You can only use VLAN and port-channel interfaces created using the interface vlan and interface port-channel commands. • You cannot create virtual interfaces (VLAN, port-channel) using the interface range command. • The no version of this command deletes the interface range. Example OS10(config)# interface range ethernet 1/1/7-1/1/24 OS10(conf-range-eth1/1/7-1/1/24)# Interfaces 101
![](/manual_guide/products/dell-s4148uon-os10-enterprise-edition-user-guide-release-1040e-r2-86f2ab4/101.png)