Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 320

• The no version of this command disables IPv6 address autoconfiguration, resets the interface in Router mode, and re-enables IPv6 forwarding. Example OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# no switchport OS10(conf-if-eth1/1/1)# ipv6 address autoconfig OS10(conf-if-eth1/1/1)# Supported Releases 10.3.0E or later ipv6 address dhcp Enables DHCP client operations on the interface. Syntax ipv6 address dhcp Parameters None Defaults None Command Mode INTERFACE Usage Information The no version of this command disables the DHCP operations on the interface. Example OS10(config)# interface mgmt 1/1/1 OS10(conf-if-ma-1/1/1)# ipv6 address dhcp Supported Releases 10.3.0E or later ipv6 enable Enables and disables IPv6 forwarding on an interface configured with an IPv6 address. Syntax ipv6 enable Parameters None Defaults None Command Mode INTERFACE Usage Information • The no version of this command disables IPv6 forwarding. • Use this command to disable and re-enable IPv6 forwarding on an interface for security purposes or to recover from a duplicate address discovery (DAD) failure. Example OS10(config)# interface ethernet 1/1/1 OS10(conf-if-eth1/1/1)# ipv6 address 2111:dddd:0eee::22/128 OS10(conf-if-eth1/1/1)# no ipv6 enable OS10(conf-if-eth1/1/1)# ipv6 enable Supported Releases 10.3.0E or later ipv6 address eui-64 Configures a global IPv6 address on an interface by entering only the network prefix and length. Syntax ipv6 address ipv6-prefix/prefix-length eui-64 320 Layer 3