Dell S4148U-ON OS10 Enterprise Edition User Guide Release 10.4.0E R2 - Page 518
seq deny ip
![]() |
View all Dell S4148U-ON manuals
Add to My Manuals
Save this manual to your list of manuals |
Page 518 highlights
• dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. • fragment - (Optional) Use ACLs to control packet fragments. • host ipv6-address - (Optional) Enter the IPv6 address to use a host address only. Default Command Mode Usage Information Example Not configured IPV6-ACL OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ipv6 access-list ipv6test OS10(conf-ipv6-acl)# seq 10 deny icmp any any capture session 1 count Supported Releases 10.2.0E or later seq deny ip Assigns a sequence number to deny IP addresses while creating the filter. Syntax seq sequence-number deny ip [A.B.C.D | A.B.C.D/x | any | host ip-address] [A.B.C.D | A.B.C.D/x | any | host ip-address] [capture | count [byte] | dscp value| fragment] Parameters • sequence-number - Enter the sequence number to identify the route-map for editing and sequencing number, from 1 to 16777214. • A.B.C.D - Enter the IP address in dotted decimal format. • A.B.C.D/x - Enter the number of bits that must match the dotted decimal address. • any - (Optional) Set all routes which are subject to the filter: • capture - (Optional) Capture packets the filter processes. • count - (Optional) Count packets the filter processes. • byte - (Optional) Count bytes the filter processes. • dscp value - (Optional) Deny a packet based on the DSCP values, from 0 to 63. • fragment - (Optional) Use ACLs to control packet fragments. • host ip-address - (Optional) Enter the IP address to use a host address only. Default Command Mode Usage Information Example Not configured IPV4-ACL OS10 cannot count both packets and bytes; when you enter the count byte options, only bytes increment. The no version of this command removes the filter, or use the no seq sequence-number command if you know the filter's sequence number. OS10(config)# ip access-list egress OS10(config-ipv4-acl)# seq 10 deny ip any any capture session 1 count Supported Releases 10.2.0E or later 518 Access Control Lists
![](/manual_guide/products/dell-s4148uon-os10-enterprise-edition-user-guide-release-1040e-r2-86f2ab4/518.png)